SPLIT FLANGES

    ALUMINUM SPLIT FLANGES

FOR CMC MAXX HOSE

Aluminum Split Flange Sigma Flange

Part Number 'D' (in.) 'A' (in.) 'B' (in.) 'K' (in.) 'P' (in.) 'Z' (# of bolts) 'H' (bolt hole ID, in.) Approx. Weight (lbs)
CMCC-2 2 3.090 0.531 4.665 6.062 4 0.748 3.3
CMCC-3 3 3.366 0.688 6.110 7.629 4 0.748 4.4
CMCC-4 4 3.425 0.787 7.755 9.055 6 0.787 6.6
CMCC-5 5 4-1/8 5/8 8-1/2 10 6 7/8 7.7
CMCC-6 6 4.507 0.787 9.527 11.023 6 1.141 8.8
CMCC-8 8 6.000 0.944 11.850 13.582 6 0.866 13.2
CMCC-10 10 6.889 1.062 14.251 16.456 10 0.984 25.4
CMCC-12 12 7-11/16 5/8 17 19 10 1 30.9

Cutting and Installation Instructions

A complete coupling assembly includes:

  • One two-piece aluminum alloy coupling with full-face integral flange drilled to ASA 150 on both halves.
  • Four or six cadmium plated steel bolts with hex nuts and washers


Cutting hose to length:

Lay out and mark the length of the hose required. Using only two bolts, temporarily install the coupling for use as a cutting guide.

Cut the hose with a knife or saw while wetting the cutting area with water.

The rubber and fabric portions of the hose are separated by pulling on the cut to make the helix accessible.

Cut the wire helix at the hose edge with wire cutters or a hack-saw


Installing the coupling:

Cross-tighten the bolts progressively, keeping the gap between the coupling halves as even as possible. Maintain this by pressing both hose ends against the seal.

Continue tightening until no gap remains between the coupling halves.

Install the gasket in the hose end, being careful to apply only as much force as required, to avoid damaging the gasket.

EXTERNAL SPLIT FLANGE GASKET

External Split Flange Gasket

Made from 1/4" Pure Gum rubber.

Available in sizes 2" to 12"

Part number: CMCG-size